R/O System (Reverse Osmosis) System
Description:
A water treatment system that will provide the
highest quality drinking water available. The reverse osmosis process
removes undesirable materials from water by using pressure to force the
water molecules through a semipermeable membrane. This process is
called reverse osmosis because the pressure forces the water flow in
the reverse direction which ultimately causes the water to be squeezed
through a membrane and then through two additional filters. This system
is not for whole house filtration. It is installed only at the point of
use, typically the kitchen sink.
Water Problems This System Treats:
The R/O system will remove the following: Ionized
salts, colloids, lead, nitrates, nitrites, uranium, and bacteria.
How It Works:
The R/O’s fine membranes will physically
screen out and remove many micro-organisms in water including
pathogenic bacteria. Reverse Osmosis is the reverse of naturally
occurring osmosis. By applying artificial pressure to a water solution
of higher solid concentration, the flow of liquid is reversed. Pressure
in excess of the natural osmotic pressure will begin to force water to
flow in the reverse direction. Under these conditions, the membrane
will allow only the water molecules to pass through and will retain the
highly concentrated salt solids. This process also squeezes out
contaminants.
Required Media:
There is no actual media required to operate this
system. However, there are filters and membranes that need to replaced
every one to three years.
Home Installation Location:
This system should be installed at the location in
your home that you use most frequently. Most are installed under the
kitchen sink. However, this system can be installed wherever you
choose. Again, the R/O will provide you with quality water, eliminating
the need to purchase bottled water.
Maintenance:
There is no media required for this system to
operate. However, there are filters and membranes that need to be
replaced. The pre-filter and post-filter will need to be replaced
annually. The membrane will need to be changed annually as well if the
water is not softened. If you have a softener, the membrane will last
one to three years.
System Specifications:
3 filters to be installed under the sink with
2" x 10" dimensions
3 gallon pressure tank
